Skoda 2009 Yeti, Owner'S Manual

Page: 228 / 252

Rear light unit
Fig. 187 Removing the rear light unit/disconnecting the plug connection
–
Open the boot lid/luggage compartment door.
– Unscrew the light with the aid of the Torx wrench from the vehicle tool kit.
The shorter side of the wrench is used for loosening the screws and the longer
side for screwing the screws out completely
1
⇒
fig. 187 .
– Grasp the light at the top and bottom part and pull it slightly to the rear.
– Disconnect the plug connection by pressing the catches in direction of arrow
2 and by pulling them in direction of arrow 3
⇒
fig. 187 .

Changing light bulbs in the rear light unit
Fig. 188 Remove the middle part of the light/rear light unit: Fitting position of the bulbs
–
Unscrew the securing screw
A
with the aid of the Torx wrench and press the
three catches in direction of arrow
⇒
fig. 188 .
–
Remove the plastic lamp holder.
– Replace the defective light bulb.
– In order to replace a bulb for the brake light, reversing light, rear fog or turn
signal light, turn the fixture of the bulb to the left up to the stop and take the
bulb out of the housing or pull the bulb for the parking light out of the fixture
⇒
fig. 188 .
– Change the bulb, install again the fixture with the bulb in the housing and turn
it to the right up to the stop or insert it.
– Insert the plastic lamp holder into the illumination unit until the interlocks are
heard to engage and screw in the securing screw with the aid of the Torx
wrench
⇒
fig. 188 .
– Reconnect the plug connector and insert the bulb in the original position.
–
Screw on the bulb
⇒
fig. 187 - left.
Fitting position of the light bulbs in the rear light unit
⇒
fig. 188
1 - Brake lights
2 - Reversing light
3 - Rear fog light
4
- Turn signal lights
5
- parking lights

Licence plate light
Fig. 189 Licence plate light
–
Unscrew the glass cover of the light
⇒
fig. 189 .
–
Take the defective bulb out of the holder and insert a new one.
£
226 Fuses and light bulbs