Page 8 of 18
Date: 2019-02-12
4. Sea Valve Assembly (Orientation not necessary).
Step 1
• Place 1.5 mm gasket, on top of Bottom Flange.
• Then place the Ball Valve element on top of the Bottom Flange. The 16 mm nuts and washers should be
mounted,
not
tightened.
• Place a 1.5 mm gasket on top of the Ball Valve element.
• Mount the intermediate element on top of the Ball Valve element. The track for o-ring to be upwards.
• All 8 nuts and washers should be mounted,
not
tightened.
Step 2
• Place the plastic alignment tube, all the way, into the sea valve.
•
Tighten 8 nuts ball valve to bottom flange.
• Tighten 8 nuts Intermediate element to ball valve.
• Remove the plastic alignment tool.
Caution must be taken when mounting seavalves that all parts are aligned correctly, and that the inside is
clean. DO NOT use liguid sealants, and DO NOT paint the inside of a valve.
Step 1
Step 2
Intermediate element
Ball valve
Plastic alignment tube
Bottom flange
SKIPPER Electronics AS
SB-100-SB Operation and Installation Manual
