SKIPPER
Electronics AS
EML224N Operation and Installation Manual
Edition: 2020-02-05
Chapter: 9. CPU Board Setup Procedure
Page 56 of 64
9. CPU Board Setup Procedure
• Connect a PC keyboard and a VGA screen to the CPU board.
• Switch “On” the unit while pressing “Delete” key on the PC keyboard.
• Do not release the “Delete” key before the “Setup” picture is present on the screen.
CPU PCA 6742VE
(Bios version 1.12). The PCA 6742 has the default settings with the following changes. Start by loading the
optimized defaults, and then change the following:
STANDARD CMOS FEATURES
Date: Change to todays date
Time: Change to time now
Halt on: No errors
Advanced BIOS Features
a. Hard Disk priority [Press enter] – Press enter
i. 1 should be ch.1 M.
ii. 2 should be ch 0 M.
b. First Boot Device [Hard Disk]
c. Second Boot Device [Hard Disk]
d. Boot other device [Disabled]
Advanced Chipset features
a. SMI712 VGA Settings [Press Enter] – Press enter
i. SMI712 VGA Monitor [Simul monitor]
ii. Panel resolution Mode [640x480 TFT]
b. USB Device Setting [Press Enter] – press enter
i. USB1.0 emulation [Disabled]
Integral Peripherals
a. Onboard serial Port 3 [enter]
i. Change to [2E8/IRQ9]
b. Onboard serial Port 4 [enter]
i. Change to [3E8/IRQ5]
c. Parallel Port Mode [EPP]
d. EPP Mode Select [EPP1.9]
PnP/PCI Configurations
a. Resources Controlled By [Manual]
b. IRQ Resources [Enter]
i. IRQ – 7 assigned to [Legacy ISA]
ii. IRQ – 10 assigned to [Legacy ISA]
iii.IRQ – 11 assigned to [Legacy ISA]
c. NO DMA
PC Health Status
a. Case Open Warning [Disabled]
SAVE SETTINGS AND EXIT
