ISSUE DATE: NOVEMBER 2017
ORIGINATOR: SKILTEC
REPLACES ISSUE DATE:
APPROVED BY: D.ALTIPARMAKOVA
PAGE 5
PRODUCT INFORMATION MANUAL
SECTION: 9F-2 DUETTE
®
POWERVIEW
®
MOTORISATION
Installation Overview
To install your shade, you will need to perform the following three steps:
STEP 1:
Install the Brackets
STEP 2:
Install the Shade
STEP 3:
Connect the Power Source
STEP 1 — Install the Brackets
■
Your order will include the correct number of installation
brackets for your shade width, as shown in the table.
➤
There are two sizes of installation brackets, one for
10mm and 20mm cell sizes and a larger one for 30mm
and 38mm cell sizes.
➤
For end mounts, two brackets are used up to the
maximum width of 1820mm.
IMPORTANT:
A 13mm spacer block is required for shades
using an attached battery wand. The spacer block is
pre-attached to the back of the installation bracket.
■
Should the spacer block become detached, reattach it.
➤
Insert the legs of the installation bracket into the
tabs on the spacer block.
➤
Rotate the installation bracket back, as shown, to
snap it in place.
Shade
Width
Brackets
Required
300mm – 914mm
2
915mm – 1828mm
3
1829mm – 2743mm
4
2744mm – 3659mm
5
3660mm – 4420mm
6
Installation
Bracket
End Mount
Brackets
Tab
Summary of Contents for Luxaflex Duette PowerView 9F-2
Page 2: ......
