ISSUE DATE: NOVEMBER 2017
ORIGINATOR: SKILTEC
REPLACES ISSUE DATE:
APPROVED BY: D.ALTIPARMAKOVA
PAGE 17
PRODUCT INFORMATION MANUAL
SECTION: 9F-2 DUETTE
®
POWERVIEW
®
MOTORISATION
Testing the Shade
Testing the shade with the manual control button will allow you to ensure that the motor and
power source are working correctly.
CAUTION:
When raising the shade for the first time, observe how the fabric stacks. It should
stack evenly. Immediately stop the shade if the bottom rail is not level or the shade starts to rub
against either window jamb. See “Level the Rail(s), If Necessary” on page 21.
■
Press the manual control button on the bottom of the
end cap to test operation. If the shade does not operate,
see “Troubleshooting” on page 22.
➤
Press the button to alternately lower, stop, and raise
the shade.
NOTE:
With Top-Down/Bottom-Up and Duolite
™
shades, the manual control button will
alternately lower the bottom rail, lower the middle rail, raise the middle rail, and raise the
bottom rail.
Using the PowerView
®
Remote
First, activate the remote by pulling both plastic tabs from the back battery compartment.
IMPORTANT:
If you have more than one remote, see “Adding Additional Remote(s) to the
PowerView
®
Shade Network” in the
PowerView Motorization Remote Control Guide.
Manual
Control
Button
Front of
Shade
Group 1
Group 2
OPEN
CLOSE
Group 3
Group 4
Group 5
Group 6
Favorite
(Shade position)
LEFT ARROW
Lowers the middle rail on
Top-Down/Bottom-Up and
Duolite shades
RIGHT ARROW
Raises the middle rail on
Top-Down/Bottom-Up and
Duolite shades
STOP
(Press and hold for
programming mode)
Summary of Contents for Luxaflex Duette PowerView 9F-2
Page 2: ......
