ISSUE DATE: NOVEMBER 2017
ORIGINATOR: SKILTEC
REPLACES ISSUE DATE:
APPROVED BY: D.ALTIPARMAKOVA
PAGE 11
PRODUCT INFORMATION MANUAL
SECTION: 9F-2 DUETTE
®
POWERVIEW
®
MOTORISATION
Mount the Installation Brackets — End Mount
End mount the headrail when conventional mounting techniques will not work — for example, in
an arched window opening.
■
Position the end mount brackets so that the top of the attached installation brackets are at
the ordered height of the shade.
CAUTION:
Both brackets must be installed at the same depth and height.
■
Mark both screw holes for each end mount bracket.
➤
The mounting surface must be vertical and flat,
not part of an arched curve.
IMPORTANT:
Add 13mm to the following minimum
mounting depths if a battery wand is used:
➤
Minimum mounting depth is 30mm for 20mm
and 10mm cell sizes. Minimum mounting depth
for a fully recessed end mount is 60mm for
20mm and 10mm cell sizes.
➤
Minimum mounting depth is 50mm for 30mm
and 38mm pleat sizes. Mininum mounting depth
for a fully recessed end mount is 75mm for
30mm cell size and 90mm for 30mm pleat size.
■
Drill the screw holes using a 3mm drill bit.
■
Attach the end mount installation brackets using the flat
head screws provided.
CAUTION:
Drywall mounting is not recommended.
IMPORTANT:
For instructions on installing an
arch over a rectangular shade, see the Installation,
Operation, and Care instructions that came with
your arch shade.
Proceed to “STEP 2 — Install the Shade” on page 12.
Summary of Contents for Luxaflex Duette PowerView 9F-2
Page 2: ......
