-21-
Assembly
10. Lower the front of the guard assembly until
the metal “fork” is parallel with the table
(Fig. 8).
11. Press down on the guard release lever until
you feel and hear it snap into the locking
position. Check that the guard assembly is
securely connected (Fig. 8).
ATTACHING THE ANTI-KICKBACK DEVICE
12. Attach the Anti-Kickback Device into the
flat, recessed area of the riving knife
(Fig. 9).
13. Squeeze the compression pads while nest-
ing the device into the flat area (Fig. 9).
Guard
Assembly
Guard Release
Lever
FIG. 8
Anti-Kickback Device
Pawls
Pin Hole
Riving Knife
Squeeze
FIG. 9
14. Release the compression pads such that
the Anti-Kickback Device locks onto the riv-
ing knife immediately behind the guard as-
sembly. Check that the attachment pin is
securely connected into the locking hole.
Carefully raise and lower the pawls – when
letting go, the spring-loaded pawls must
come down and contact the table insert
(Fig. 9).
Hint: Position the Anti-Kickback Device behind
the flat recessed area and slide it towards the
front until it drops into the recessed area – then
release the compression pins.
NOTE: The two attachments are independant
of each other, so the Anti-Kickback Device can
be attached before the Guard Assembly.
