-16-
STAND ASSEMBLY HARDWARE (PACKAGED IN ONE BAG)
Itm. Qty.
Figure
Part Description
A
2 ea
5/16 in. x 2 in. carriage bolt (for handle bar) with
washer and lock nut
B
4 ea.
5/16 in. x 3.5 in. carriage bolt (for h-shaped frame)
with black plastic spacer, washer and lock nut
C
2 ea
11/16 in (7mm) washer and lock nut for wheels
D
4 ea
5/16 in. x 3.5 in. carriage bolt (to mount tool to
stand) and lock nut
Unpacking and Checking Contents
Tools Needed for Assembly and Adjustment
COMBINATION SQUARE MUST BE TRUE
drawn line
3/4" board with
straight top edge
no gap or overlap
1. Position square and
draw a light line
2. Flip square
(shown in dotted position)
3. Check edge of flipped
square against the drawn line.
There should be no gap or
overlap at the bottom end.
Disconnect the plug from the power source before performing any assembly,
adjustment or repair to avoid possible injury.
Phillips & Flat Head
Screwdriver
Adjustable Wrench or
1/2 inch Wrench and
11/16 inch Wrench
Combination Square
Blade Wrench
(supplied)
5 MM Hex “L” Wrench
(supplied)
