19
Removing and Installing The
Table Insert (Fig .7)
To remove table insert, press the button with
your thumb and place your index finger into the
finger hole to lift and pull the table insert out
toward the front of the saw.
To install table insert, align and insert the two
tabs on table insert with the two pockets in the
tabletop and pivot the table insert downwards.
Verify that the table insert is seated.
NOTICE: The table insert is adjustable and,
therefore, can change over time. Verify that the
table insert is set correctly before every use.
If adjustment is needed, follow the “Adjusting
The Table Insert” instructions.
Attaching the Smart Guard System
WARNING
To prevent personal
injury, always disconnect
the plug from the power source before
attaching or removing the Smart Guard
System .
Positioning the riving knife
1. Remove the table insert (see “Removing
and Installing The Table Insert ”).
2. Raise the blade as high as it will go by
turning the elevation wheel clockwise and
set it perpendicular to the table (0° on bevel
scale) (Fig. 8).
3. Rotate the release lever clockwise, so that
it points upward (Fig. 8).
4. Pull the riving knife toward the release
lever to disengage the upper hole of the
riving knife from the pin (Fig.9).
Fig. 7
1
2
Fig. 8
B
Release Lever
Fig. 9
Upper Hole of the Riving Knife
Button Finger Hole
Table Insert
Riving Knife
Pin
