18
Unfolding The Stand Legs Before Assembly
WARNING
T
o reduce the risk of personal injury, do not operate table saw until
you have read and understand the followings:
•
The table saw is integrated with the stand when shipped . Check the stand to make
sure that it is still securely fastened to the table saw before any operation . A loose
stand is unstable and may shift in use and cause serious injury .
•
Do not stand on the table saw stand or use it as a ladder or scaffolding .
•
Do not use table saw if the stand tips, slides, or moves in any way .
•
Before operating the table saw, ensure that the entire table-saw/stand assembly is
secure and placed on solid, level surface .
•
Use only SKIL replacement parts for the stand . Any others may create a hazard .
1. Place the table saw on a clean level surface with the tabletop facing the ground (Fig.5a).
2. Press the red button of the stand while unfolding the stand leg. Do not release the red
button until the stand leg has been folded completely (Fig.5a).
3. Repeat the above operation to unfold the other three stand legs in turn.
4. Lift the
carrying handle until the table saw is vertical
(Fig.5b).
Fig. 5a
Fig. 5b
Installing The Drive Knob
(Fig .6)
Attach the drive knob onto the mounting hole.
While holding the drive knob to prevent it from
moving, install the included hex screw and
washer into the drive knob and the mounting
hole , then use the Double-Ended Allen
Wrench (included) to secure the hex screw in
place.
Fig. 6
Mounting
Hole
Drive Knob
Washer
Hex Screw
