34
Mounting Applications
Mounting the Miter Saw to the Stand
(Not included, available as accessory
See Figures 12 - 13.
1. Rotate the two quick clamp knobs
1
on each side of
the rear portion saw base counterclockwise until
the clamps are retracted as far as it willl go.
2. Lift the saw, allowing it to tilt slightly away from your
body.
3. While still tilted away from you, hook the rear edge
of the saw base onto the rear rail
2
of the stand,
figure 12.
To avoid serious personal injury,
make sure the curved rear edge of
the saw base and clamps are securely seated over
the rear rail before seating the other end of the
saw base.
Failure to do so could cause you to lose
control of the saw mounting assembly.
4. Lower the saw to allow the front edge of the saw
base to seat fully over the front rail, figure 13.
5. Check position and adjust, if necessary, to make
sure the weight of the saw is evenly balanced over
the rails as shown in figure 13.
6. Rotate the two quick lock knobs
1
clockwise and
securely tighten.
7. Ensure the saw base is fully seated and locked in
position.
To remove saw from stand:
1. Rotate the two quick clamp knobs counter
clockwise.
2. Lift the saw away from the front rail of the stand to
disengage.
3. With the assembly tilted slightly away from you, lift
the rear part of the saw base to disengage from the
front rail of the stand.
WARNING
!
FIG. 12
1
2
1
FIG. 13
Installation
SM 2610017175 08-11:SM 2610017175 08-11.qxp 8/2/11 11:24 AM Page 34
