32
Mounting Applications
Workbench
Mount the saw to the workbench using the four mounting
holes (5/16
"
)
1
to the workbench (Figure 10). Check for
clearance to the left and right of the saw.
1.
Each of the four mounting holes
1
should be bolted
securely using 5/16” flat head screws, lock washers, and
hex nuts (not included).
2.
Locate and mark where the saw is to be mounted.
3.
Drill four (4) 5/16” diameter holes through workbench.
4.
Place the compound miter saw on the workbench
aligning holes in base with holes drilled in workbench.
Install screws, lock washers and hex nuts.
Supporting surface where saw is to be mounted should be
examined carefully after mounting to insure that no movement
can occur during use. If any tipping or walking is noted, secure
the workbench or stand before operating the compound miter
saw.
Portable Mounting Using Clamps
•
If necessary, clamp the compound miter saw to a
workbench or table top.
•
Place three or more “C” clamps on the clamping areas
and secure (Figure 11).
NOTE: Always make sure you leave enough room in work
area to accommodate long workpieces.
Installation
1
1
1
1
3
2
4
5
1
6
7 8
9
30
15
31.6
22.5
45
0
3
2
4
5
1
6
7 8
9
30
15
31.6
22.5
45
0
FIG. 10
FIG. 11
SM 2610017175 08-11:SM 2610017175 08-11.qxp 8/2/11 11:24 AM Page 32
