48
Compound Cuts
•
A compound cut is a cut requiring both a miter setting and
a bevel setting.
•
Because it may take several tries to obtain the desired
compound angle, perform test cuts on scrap material
before making your cut.
Follow these instructions for making your
compound cut:
1.
Select the desired miter and bevel angles). (See Miter Cut
and Bevel Cut on pages 44 and 46.)
Before sawing, always check that there
is no interference between moving and
stationary parts of the saw.
Do not operate the saw in the
following range of miter and bevel combinations: Left Miter 46°
to 48° at bevel angles 35° and greater. These miter and bevel
combinations may result in interference between the lower
guard and the work piece clamp.
2.
Properly position workpiece. Make sure workpiece is
clamped firmly against the table and the fence.
3.
Make sure all controls are locked before cutting.
Always use clamp to hold workpiece
against the table and fence when making
compound miter cuts. Do not support by hand. Use clamping
position that does not interfere with operation. Before
switching on, lower head assembly to make sure clamp clears
guard and head assembly.
4.
Activate the switch. Lower the head assembly and make
your cut.
5.
Wait until blade comes to a complete stop before
returning head assembly to the raised position and/or
removing workpiece.
Saw Operations
FIG. 30
WARNING
!
WARNING
!
See Warnings on page 5
Voir les avertissements à la page 12
Consulte las advertencias que están en la página 19
SM 2610012178 07-10:2610007743 07-09 3315 7/8/10 1:56 PM Page 48
