Skier's Choice Moomba Kamberra, Owner'S Manual

Page: 30 / 66

30
© 2002 Skier’s Choice, Inc.
Blower Switch
The blower switch activates the blower motor. The primary
function of the blower fan is to remove any fumes from the
bilge area. The blower also draws fresh air into the engine
compartment.
Never depend solely on the blower to eliminate dangerous
fumes. Before starting the engine, always open the motor
box to check if fumes are present.
Switch on the blower fan a minimum of four minutes before
starting the engine.
NOTE: If the blower fails to operate, reset the circuit
breaker located on the circuit breaker panel under the
dashboard. If the blower still does not operate, notify
your Moomba dealer.
Ignition Switch
Located on the port side of the dashboard, the ignition switch
has three positions. In the vertical position the ignition is OFF.
With the key in, turn the ignition switch one notch to the right
to check all electrical equipment, including blower, pump,
and lights. Turn the ignition all the way to the right to operate
the starter.
NOTE: All electrical equipment should be turned off
when the boat is in storage.
Accessory Switches
The accessory switch supplies power to an extra circuit for
accessories that may be added (such as heaters, hot water
showers, etc.)
NOTE: If accessories fail to operate, press the circuit
breaker under the dash. If the accessory still does not
operate, notify your Moomba dealer.
Tilt Steering
Tilt steering may be adjusted up or down in five different
locking positions. To adjust, depress the tilt lever located
beneath the bezel and move the steering wheel to the desired
position. Release the lever to lock the wheel into place.