Ski-Doo MX Z Iron Dog, Operator'S Manual

Page: 124 / 147

MONITORING SYSTEM
PILOT LAMP(S)
ON
BEEPER
MESSAGE
DISPLAY
DESCRIPTION
—
Displayed when brake is applied
for more than 15 seconds while
throttle lever is squeezed and
vehicle is moving at more than
5 km/h (3 MPH).
—
4 short
beeps
every
5 minutes
KNOCK
Engine detonation (RPM is limited
when this condition occurs).
– Ensure recommended fuel is
used.
– Check fuel quality, replace if
necessary.
– If fault still occurs, contact an
authorized Ski-Doo dealer.
—
4 short
beeps
every
5 minutes
REV LIMIT
Engine RPM limited for protection
when certain faults occur.
— —
OVER REV
Indicates that maximum engine
RPM is reached. Check clutch
calibration.
—
Short
beeps
repeating
rapidly
SHUTDOWN
Shutdown procedure in force
due to engine overheating or fuel
pump problem,
remove tether
cord cap from engine cut-off
switch and contact an authorized
Ski-Doo dealer.
— —
COMMUNICATION
Communication problem between
ECM and gauge. Stop engine,
remove tether cord cap. Wait a
few minutes, then start engine.
If problem persists, contact an
authorized Ski-Doo dealer.
2 short
beeps
—
Good key, vehicle ready to
operate.
Short
beeps,
repeating
slowly
CHECK KEY
Unable to read key. Make sure the
key is correctly snapped on post.
DESS
Short
beeps
repeating
rapidly
BAD KEY
Invalid key or key not
programmed. Use the proper
key for the vehicle or have the
programmed.
122
______________