SKF LUBRILEAN Vario, Operating Instructions Manual

Page: 23 / 32

Malfunctions Page 23
EN
Continuation Table 3. Malfunctions and how to fix them
Complaint Possible cause Solution
The junctions between spindle and
tool-receiving socket are unfavourable. Use only the tool-receiving sockets
suited for minimal quantity lubrication.
The tool-receiving socket is not tight. Use only the tool-receiving sockets
suited for minimal quantity lubrication.
The tool has an unsuitable intake and a
very small cooling channel. Use only the tools suited for minimal
quantity lubrication.
No aerosol is applied
to the tool.
For small tools: the primary pressure is
too low. Increase the primary pressure.
The tool has an unsuitable exit hole. Use only the tools suited for minimal
quantity lubrication. Despite sufficient
aerosol discharge on
the tool, processing is
faulty.
The cut parameters are not adapted to
processing using minimal quantity
lubrication. Modify the cut parameters.