SKF LUBRILEAN Vario, Operating Instructions Manual

Page: 14 / 32

Assembly Page 14
EN
160
4x9
3
5
0
9 Assembly
The scope of delivery of the MQL system
L
UBRI
L
EAN
®
Vario includes a mounting bracket,
which is attached to the rear side of the aerosol
container. This bracket is used to attach the
MQL system to the machine tools.
Fig. 5 contains the fitting dimensions for
assembly of the MQL system L
UBRI
L
EAN
®
Vario.
Connecting the system must only be
performed by appropriately qualified
and trained personnel. The indications
contained in these operating
instructions must be respected.
Fig. 5. Drill hole plan
9.1 Connector for aerosol outflows
The MQL system L
UBRI
L
EAN
®
Vario is equipped
with three aerosol outlets (no. 1, Fig. 1), which
are set up as a plug-and-socket connection for
hoses with an outside diameter of 12 mm.
Only pneumatic hoses may be used
that are suited for an operating
pressure of at least 10 bars and are
stable when used with the type of
lubricant used.
In general, only one pressure discharge is used.
The two alternative outflows are sealed with
closing stoppers.
Before loosening the closing stoppers,
the pressure in the container must be
released.
The lubricant quantity which is discharged on
the tool in the form of the aerosol depends on
several factors including the existing conduit
and line cross sections of the aerosol transport
route from the MQL system to the outflow
opening on the tool.
To avoid a loss of aerosol and pressure in the
transport to the point of application, you should
observe the following rules: