Skandika Fitness ISIS 23, Setup And Instruction Manual

Page: 29 / 52

29
SAFETY INSTRUCTIONS / PARTS LIST
• Assemble the exerciser as per assembly instructions and be sure to only use the structural parts provided with the exer-
ciser and designed for it. Prior to the assembly, make sure the content of the delivery is complete by referring to the parts
list of the assembly and operating instructions.
• Be sure to set up the exerciser in a dry and even place and always protect it from humidity. If you wish to protect the place
particularly against pressure points, contamination, etc., it is recommended to put a suitable, non-slip mat under the exer-
ciser. Do not place the device on a carpet!
• The general rule is that exercisers and training devices are no toys. Therefore, properly informed or instructed persons
must only use them.
• Stop your work-out immediately in case of dizziness, nausea, chest pain or any other physical symptoms. In case of doubt,
consult your physician immediately.
• Children, disabled and handicapped persons should use the exercise only under supervision and in presence of another
person who may give support and useful instructions.
• Be sure that your body parts and those of other persons are never close to any moving parts of the exerciser during its use.
• When adjusting the adjustable parts, make sure they are adjusted properly and note the marked, maximum adjusting po-
sition, for example of the saddle support, respectively.
• Do not work out immediately after meals!
Part no. Description
Specifications Q‘ty
1 Rear support frame 40x80x1,8tx500 1
2 Main frame 40x80x1,8tx715 1
3 Front stabilizer 50.6x95.4x2tx400 1
4 Rear stabilizer 50.6x95.4x2tx480 1
5 Front stabilizer cap (L & R) 50.6x95.4mm 2
6 Rear stabilizer cap (L & R) 50.6x95.4mm 2
7 Handlebar post 1
8 Seat post 30x60x1,5tx585 1
9 Handlebar 22x1,5t 1
10 Seat rail 30x60x1,5x428 1
11 Crank(L & R) ED/BK 2
12 Fastener 40x80x1,8tx120 1
13 Oval post 22x1,5t 1
14 Hand pulse sensor 2
15 Fastener (for #8) 40x80mm 1
16 End cap 30x60mm 2
17 Hand pulse sensor wire 1
18 Motor 1
19 End cap ø22mm 4
20 Allen key wrench 5mm 1
21 Foam grips (for #9) 20x530x5t 2