1
HT
[Name]
Horizontal tab
[Format] ASCII HT
Hex 09
Decimal 09
[Decription]
Moves the print position to the next horizontal tab position.
[Details]
•This command is ignored unless the next horizontal tab position has been set.
• If the next horizontal tab position exceeds the printing area,
the printer setstheprinting position to [Printing area width + 1].
• Horizontal tab positions are set with ESC D.
• If this command is received when the printing position is at [printing area width
+ 1], the printer executes print buffer-full printing of the current line and
horizontal tab processing from the beginning of the next line.
[Reference]ESCD
LF
[Name]
Print and line feed
[Format]
ASCII
LF
Hex
0A
Decimal
10
[Description]
Prints the data in the print buffer and feeds one line based on the current linespacing.
[Note]
This command sets the print position to the beginning of the line.
[Reference] ESC2
，
ESC3
DLEDC4nmt
[Name]
Real-time pulse generator
[Format]
ASCII
DLE
DC4 n m t
Hex
10
14 n m t
Decimal 16
20 n m t
[Range]
n=1,m=0,1
1
≤
t
≤
8
[Decription] Output pulse is specified by the parameter t connection pins, “m” show as below
：
m
Connect Pins
0
Cash Drawer Connect Pin 2
1
Cash Drawer Connect Pin 5
Pulse high time for[t*100 ms]
，
low time for [t*100ms]
。
[Details] • When the printer is executing a command to open the cash drawer (ESCp or DELDC4),
the command is ignored.
• In serial mode, the printer immediately after receiving the order.
• In parallel mode, the printer is busy when the command is not executed.
• If the print data same as the command contains data, the data will be used as the command
is executed. The user must take into account this situation.
• Don’t try to insert the command in two or more bytes in the command sequence.
• Even if the printer is set to disabled by the command of ESC = (select peripheral), the
order is still valid.
[Reference]
ESCp
ESCSPn
[Name]
Setting the right side character spacing
[Format] ASCIIESC
SP n
Hex1B
20 n
