Sitten BT850A, Programmer'S Manual

Page: 17 / 33

15
[Format] ASCII ESC m
Hex 1B 6D
Decimal 27 109
[Description]Select Cut mode and half cut
FSpnm
[Name]
Print NV bit image
[Format] ASCII
FS p n m
Hex
1C 70 n m
Decimal
28 11 n m
[Range]
1
≤
n
≤
255
0
≤
m
≤
3,48
≤
m
≤
51
[Description] Prints a NV bit image n using the mode specified by m.
m
Mode Vertical DotDensity Horizontal Dot Density
0 ， 48
Normal
203.2dpi 203.2dpi
1 ， 49
Double-width
203.2dpi 101.6dpi
2 ， 50
Double-height
101.6dpi 203.2dpi
3 ， 51
Quadruple
101.6dpi 101.6dpi
dpi: dots per 25.4 mm {1"}
•
n is the number of the NV bit image (defined using the FS q command).
•
m specifies the bit image mode.
[Note]
•
NV bit image means a bit image which is defined in a non-volatile memory
byFS q and printed by FS p.
•
This command is not effective when the specified NV bit image has not been
defined.
•
In standard mode, this command is effective only when there is no data in the print
buffer.
•
Thiscommand is not affected by print modes
(emphasized, double-strike,underline,character size, white/black reverse printing,
or 90° rotated characters, etc.),except upside-down printing mode.
•
If the printing area width set by GS L and GS W for the NV bit image is
less than onevertical line, the following processing is performed only on
the line in question. However,in NV bit image mode, one vertical line
means 1 dot in normal mode (m=0, 48) and indouble-height mode (m=2,
50), and it means 2 dots in double-width mode (m=1, 49) andin quadruple
mode(m=3, 51).
①
The printing area width is extended to the right in NV bit image mode up to
one linevertically. In this case, printing does not exceed the printable area.
②
If the printing area width cannot be extended by one line vertically, the left
margin isreduced to accommodate one line vertically.
•
If the downloaded bit-image to be printed exceeds one line, the excess data is
notprinted.
•
This command feeds dots (for the height n of the NV bit-image) in normal
anddouble-widthmodes, and (for the height n × 2 of the NV bit-image) in
double-height andquadruple modes,regardless of the line spacing specified by
ESC 2 or ESC 3.
•
After printing the bit image, this command sets the print position to the beginning
of thelineand processes the data that follows as normal data.
[Reference] ESC*, FS q, GS /, GS v0
FSqn
[
xLxHyL yHd1...dk
]
1
...
[
xLxHyLyHd1...dk
]
n