30
To assemble the center rake wheel kit, proceed as follows (Fig. 4.27):
1) Remove the four bolts that connect the drawbar at the four holes in the plate (1).
2) Fasten the plate (1) using the long bolts (2) and the bolt (10) and nuts (3).
3) Attach the arm (4) to the plate (1) using the pin (6), washers (5) and spring pins (7).
4) Attach the hydraulic cylinder (12) with the spacers (11) to the plate (1), using the pin (8), washers (17)
and spring pins (9).
5) Connect the arm (4) to the cylinder at hole (16) with the milled pin (13), washer (14) and spring pin (15).
6) Insert the spring hook (21) into the hole (22) in the plate (1).
7) Insert the bolt (19) into the hole of the milled pin (13).
8) Screw the nuts (20) onto the bolt (19), until a few millimeters of the threading protrude (about 3-4mm).
The tension of the spring must be adjusted according to the desired pressure of the rake wheel on the
ground.
9) Fasten the rake wheel (23) to the arm (4) using the bolts (24), washers (25) and nuts (26).
Pos. Qty. Description
2
4
BOLT TE M16 X150 (5/8"x5"57/64) DIN 931 8.8
3
5
NUT M16 (5/8") DIN 980
5-14-17
5
FLAT WASHER ø21 (ø13/16") DIN 125A
6-8
2
PIN ø20 (ø25/32")
7-9-15
5
SPRING PIN ø6x35 (15/64"x1"3/8) DIN 1481
10
1
BOLT M16x40 (5/8"x1"9/16) DIN 933 8.8
11
2
SPACER ø 20.5/34-23 (25/32"-1"21/64x57/64")
13
1
PIN ø20/25 (ø25/32"-1”)
20
2
NUT M10 (25/64") DIN 934 8
24
6
BOLT M10x25 (25/64"x1”) DIN 933 8.8
25
6
SPLIT WASHER ø10.5 (ø26/64") DIN 127B
26
6
NUT M10 (25/64") -DIN 934
Summary of Contents for QRX 12
Page 1: ...ASSEMBLY USE AND MAINTENANCE QRX 12 14 201600 ...
Page 2: ......
