sitrex HM 360, Assembly, Use And Maintenance

Page: 14 / 60

GENERAL SUMMARY OF SAFETY AND ACCIDENT - PREVENTION INSTRUCTIONS
12
38-
On disconnecting the Cardan shaft, replace the protective hood on the power takeoff shaft.
39-
Prolonged use of the machine can cause the drive boxes to become hot. To avoid any risk of getting
burnt, avoid touching these areas both during
use and some time afterwards.
40-
Periodically check screws and nuts for tight-
ness and grip. Tighten if necessary.
41-
When carrying out maintenance work or re-
placing the blades, raise the machine and rest
on adequate supports.
42-
Use the quantities of grease and oil advised.
43-
Spare parts must meet the requirements as
defined by the manufacturer. Use only original
spare parts.
44-
Safety decals must always be clearly visible.
They must be kept clean and replaced if they
become too illegible (they can be ordered from
the agent if necessary).
45-
The instruction booklet must be available for
the lifetime of the machine.
3.2