sitrex BR 2030/6, Assembly Instructions Manual

Page: 47 / 62

43
Option B
– Auxiliary power wiring harness
The rake can be also powered through the three-way power connector on the tractor using the auxiliary
power wiring harness which provides the proper three-way connector to attach to the tractor and the 4-way
connector to attach to the wiring harness of the rake at the tongue.
If the auxiliary power wiring harness is used to power the rake, pull the four-way connector on the rake wir-
ing harness out of the tongue and remove the cap (
Fig.3.7.4 ).
Store the cap in a safe place, as you must install the cap again if the rake is powered using the seven-way
receptacle on the tractor.
Attach the four-way connector on the auxiliary power wiring harness to the connector on the rake, then at-
tach the three-way power connector on the auxiliary power wiring harness to the receptacle on the tractor
(
Fig.3.7.5 ).
The rake requires 12 V at pin (B) (blue wire) and a ground source at pin (A) (white wire). It is recommended
that the tractor is configured for switched power for pin (B) to avoid draining the battery when the tractor is
off.
3.7.3
3.7.4 3.7.5