4
Assembly sequence (MKE/18-20)
3)
DANGER
Lay the hose 2 along the drawbar following the A points where the existing hose is
fixed until the female end of the same is in the center of B machine’s frame. Now,
after having removed the existing screws, lock at A points the hose 2 with the
collars 3 and screws 4. In this stage, do not tighten completely the collars 3 and the
screws 4. Fix the rapid coupling 1 to the hose 2. It is recommended to put some
Loctite to avoid oil leakage.
In this step, you will use:
Item 1: 1 rapid coupling ½” NPT
Item 2: 1 hose 3/8” l. 12950- 510” male1/2” NPT female ¾” jic
Item 3: 18 hose collars ø18 – ø0.71”
Item 4: 18 screws M8x60 (0.31” x 2.36”)
4) DANGER
See next page (For all models)
Lay the hoses 1 following the way of the existing hoses A and bring the female ends
of the same at the center of frame B. Now join the hoses 1 and the hose 2 to the
fitting 3 , without tightening completely. Now, after having removed the existing
screws, lock the hoses 1 at the points E with the collars 6 and the screws 7. During
this stage, do not tighten completely the collars 6 and the screws 7. Remove the cap
C from the cylinders. Fix the hose 1 at point D through the
washers 4 and the screw 5.
