Siterwell GS690, Installation And Service Manual

Page: 50 / 63

50
Document NO.: RD-690-39-001 Version: A Date
：
2017.12.30
If this occurrence repeats, disable the zone and contact the service company.
5.2.2 Audio/Visual Alarm Device Silence/Activation
The audio/visual alarm devices will activate during the Alarm Condition. If all occupants have evacuated the building, or
the cause of the Alarm Condition was not a fire, then the alarm devices (both audible and visual) can be silenced. To
silence/active alarm devices, take the following actions:
1) Enter Access Level 2.
2) Press
【
SILENCED/ALARM
】
button. The
【
SILENCED/ALARM
】
button will toggle the audio/visual alarm devices
between off and on.
3) To exit to Access Level 2, press ESC twice.
5.2.3 Delays Active Override
If Alarm Condition delays have been configured, audio/visual alarm devices and output module activations will be
delayed until the pre-set time has expired. When delays have been configured and an alarm is received from an initiating
device, the DELAYS ACTIVE LED will be on.
To override pre-programmed delays to the Alarm Condition, take the following actions:
1) Enter Access Level 1.
2) Press the DELAYS ACTIVE button. The audio/visual alarm devices configured for operation will activate.
5.3 Fault Condition
When a fault occurs with a device or within the control and indicating equipment, the control and indicating equipment will
enter the Fault Condition. In the Fault Condition, the internal sounder will operate.
5.4 Actions During the Fault Condition
5.4.1 Fault Investigation
After the control and indicating equipment enters the Fault Condition, take the following actions.
1) Enter Access Level 2.
2) Press
【
ACK
】
to acknowledge the Fault and silence the internal sounder. The FAULT LED will be on steady and the
internal sounder will silence.
3) Read the details of the alarm event on the LCD and investigate the source of the Fault Condition.
DO NOT RESET THE CONTROL AND INDICATING EQUIPMENT UNTIL THESOURCE OF THE FAULT HAS
BEEN DETERMINED.
4) Once the cause of the fault has been rectified, press the
【
RESET
】
button to reset the fire detection and alarm
system.
5) If the cause of the fault has not cleared, the control and indicating equipment will re-enter the Fault Condition. If this
occurrence repeats, disable the zone and contact the service company.
5.4.2 Multiple Devices in Fault
If more than one fault has occurred, the QUEUE REVIEW FAULT LED will flash. Press the
【
FAULT
】
button to scroll
through the list of devices.