Siser TS DUE, Instructions Manual, Page: 11 / 17

This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 22 rev.2 - last updating: 01/2015
Sublimation-program (03)

Press button S

The display shows up 03, followed by the audible signal and blinking

On the display the preset parameters appear: 200°C and 60 seconds
The operator may change the preset parameters with buttons
„+“ and „-„
.
The modified parameters may be saved directly by pressing button S and may
always be recalled and altered again.
The preset temperature may be modified in each program (01…02…03) plus or
minus 20 °C. For the standard program however, temperatures between 0°C and 250° may be adjusted.
Display signals
In case of failures, the new control board TS2 3P gives different signals in order to
discover and resolve the problem immediately.

If 111 appears on the display and the light blinks, followed by an acoustic
signal, the temperature sensor is defect or not connected with the control board.

If 000 appears on the display and the light blinks, followed by an acoustic
signal, the temperature ranges about 15°C because of a default. The control board has to be checked.
9. Maintenance
Following the safety directions mentioned below is essential to avoid severe injuries to the operator and / or
damage to the transfer press.
Before performing any maintenance work, the transfer press must have been switched off and the plug
must have been removed from the power socket.
Note the high temperatures of the heating plate (top). It can take up to 15 minutes until the plate has cooled
down to a temperature below 50° C.
Carefully follow the instructions mentioned in this manual before performing any maintenance or cleaning work
on the transfer press.
Maintenance work must only be performed by skilled and specially trained staff.
Before switching on the unit again after maintenance or cleaning work, ensure that no tools or spare parts
have been left in or on the unit and that shrouds, safety appliances, graphic symbols and instructions attached
to the press are in good condition and easy to read.