This manual is the property of SISER S.r.l., any even partial reproduction is forbidden
Mod. PRD 22 rev.2 - last updating: 01/2015
Operating Parameters
Please set the operating parameters (time and temperature) by using the display and the LEDs on the control
panel.
Annotations
1. After you have pressed the "S" button (SET), "01" starts flashing on the display. When the flashing has
stopped, set the desired temperature in Celsius on the electronic display: "+" rises the temperature, "-"
lowers the temperature. When the desired temperature is reached, confirm by pressing the "S" button.
2. After that you have to set the desired pressing time in seconds: "+" extends the time, "-" reduces the time.
If the switch is pressed a second time, the data is saved and the temperature set before is shown again
on the display. The heat transfer press is ready for use as soon as the desired temperature is reached.
It is always possible to check time and temperature by tapping the "S" button.
Working programms
With the new control board
TS2 3P
4 different programs may be saved: the standard program in addition to 3
new programs dedicated to Flock, Flex or Sublimation transfers. Thanks to this new system you only need to
enter the right parameters in order to transfer quickly.
Parameter adjustment
Standard-program
(00)
Please press the button
S
for 25/30 seconds. The display confirms the access to the program by showing
00
followed by a flashing and audible signal.
In order to modify the program, please press again the button
S
for 25/30 seconds.
Flex-Program (01)
Press button
S
The display shows up
01,
followed by the audible signal and blinking
On the display the preset parameters appear:
160°C
and
15
seconds
Flock-Program (02)
Press button
S
The display shows up
02,
followed by the audible signal and blinking
On the display the preset parameters appear:
150°C
and
15
seconds