7
English
WARNING!
Do not alter the data on the
plate for any reason.
-
Do not
use nor store the machine inside a cold room: this could seriously
damage the
electrical components sensitive to condensate (which forms at low
temperatures) and also alter
the viscosity of the grease and/or lubricating oil in
the gearbox housed inside it, jeopardising the
machine’s correct operation and
causing potential failures.
-
Do no
access the electrical components without first disconnecting the machine
from the
mains supply:
risk of electric shock
.
- do not pro
ess products that are larger than what can be totally contained in the
loading
hopper.
- do not
wear garments that do not comply with safety regulations. Consult your
employer
about the requirements of safety in effect and the protective devices to
be used.
-
Do no
start the machine during a breakdown.
- Before usi
g the machine, make sure that any unsafe condition has been
properly removed.
In case of any irregularities, stop the machine and warn those
responsible for maintenance .
-
Do not
allow unauthorized personnel to service the machinery.
The first aid emergency treatment in case of accident caused by electric current
is to remove
the person from the conductor (as he has usually passed out).
This operation is dangerous. The victim in this case has become a conductor:
touching him
means being electrocuted.
Therefore remove the contacts directly from the supply valve of the line, or if that
is not
possible, remove the victim using insulating materials (sticks of wood or
PVC, fabric, leather,
etc.). The patient should be immediately seen by medical
staff and admitted to a hospital.
1.7 – Identifying Data
An exact description of the "
Model”,
the “
Serial number”
and the “
Year built
" of
the
machine will facilitate rapid and effective responses by the our Support Ser-vice. It is
recommended to indicate the equipment model and serial number when-ever you contact the
support service.
Collect the data from the plate shown in
Fig. 1.7.1. As a reminder, we suggest Machine model….………………………..
reporting
the data in the machine you Serial number……………………………..
have, in the table
Year built ……………………….…………
Type.......................................................
A= model of the
machine
B= Power supply
C= motor power
D= motor frequency Hz
E= Weight
F= Amperage
G= Year of manufacture
H= Serial Number
I= Manufacturer
L= Bar code
A
B
C
D
E
F
G
H
I
L
Fig. 1.7.1
Summary of Contents for TC 22
