Sirman TC 22, Instruction Manual For Use And Maintenance

Page: 5 / 22

6
- use contra y to the regulations of the country of use;
- lack of or un kilful maintenance;
- use of spare parts, not original and not specific for the model;
- total or partial failure to comply with the instructions.
1.4 – Description of the machine
The meat grinder in your possession is a simple, compact, highly efficiency and powerful
machine.
- As it is supposed to be used for chopping food, the components that can come in contact with the
product have been carefully chosen to ensure maximum hygiene. The housing is made of stainless
steel AISI 304.
- The hopper is made of stainless steel AISI 304 to ensure maximum hygiene and
easy cleaning.
- The plates and knives are made of grade AISI 430 stainless steel; therefore, they may rust if they
are left immersed or wet. We recommend drying them after they are washed.
- Feed and rotor of cast stainless steel AISI 304 with the possibility of applying the UNGER system
in whole or part.
- Possibility of reversing the direction of rotation using a switch
- Rigid locking of the feed to improve the cut of the meat and extend the life of the
plates and
blades.
- Ventilated motors either three-phase or single phase with the following advantages:
- consistency of performance and durability of the engine;
- increase in the effective operating time due to fewer interruptions;
- low rate of heat to keep the meat fresh and unaffected.
The models shown in this manual have been produced according to
EEC Directive 2006/42, as
amended.
In case of accident, no liability can be assigned to the manufacturer if the machine
has been
modified, tampered with, deprived of safety guards or used for purposes not intended by the
manufacturer.
1.5 - Intended Use
The machine is designed and manufactured to grind meat or fish up to a maximum temperature of
7°C. After every work cycle, we recommend not leaving any food inside the grinding inlet or on the
trays for long periods (maximum 5 minutes). The meat grinder must be used in professional
environments by qualified operators who have read and understood this manual. Use the machine
only when safely supported on a solid work table. The size of the meat to be ground must be such
as to fit completely in the inlet feed and not overflow the hopper.
1.6 - Prohibited uses
The machine must only be used for the purposes intended by the manufacturer, in particular:
- do not use the machine for chopping foods other than meat and the like.
- do not use the machine if not properly installed with all the guards intact and
properly installed to
avoid the risk of severe injury.