18
-
The system -B- (partial UNGER), replaces the knife "5" and plate "4" with the
spacer "7".
-
The system -A- (Normal) is the easiest method of transport, composed only of the
AISI 304
stainless steel rotor, a knife and an output plate, both in AISI 430 steel.
It is not possible to mount the plates of the B or C unit on models with A grinder; it is necessary to
change the entire unit.
6.3 - Using the grinder
1 Make sure that the supply voltage matches the value on the rating plate.
The voltage indicator
will be lit to indicate the connection to the electric grid.
2 Slightly tighten the ring nut of the meat grinder and put in some meat, press the start button,
making sure that the direction of rotation is the same as that indicated by the arrow
(counterclockwise).
3 If the meat output is cut well, the adjustment of the ring nut is fine, if not, tighten the ring nut
more until you get a perfect cut of meat.
4 Stop the machine by pressing the stop button
5 To loosen the ring nut it is not necessary to use a tool, simply turn the handle that locks the feed,
because the ring nut is free and can be easily extracted.
6 After a thorough cleaning, first mount the feed, making sure it is in the correct position and
secure it with the side handle.
7 Now you can reassemble the rotor, the knife, the plate and the ring nut.
6.4 - Dismantling and cleaning the mouth after use
1 Empty the mouth and inlet collar completely and then start the machine without any meat in it.
2 When you are sure that no processing residues are left in the collar and mouth, switch the
machine off and disconnect it from the mains electricity.
3 Loosen the nuts fastening the mouth.
4 Detach the mouth completely and place it on a support surface. You can now dismantle the
components of the mouth.
5 Loosen the ring nut fully until it slides off.
6 Extract the plate and knives, followed by the worm.
7 Clean every component.
6.5 - Assembling the mouth after cleaning
After properly cleaning each component, reassemble the mouth:
1. Insert the grinding worm.
3. Insert the knife and plate, while making sure that the knife is mounted with the blade facing the
grinding plate.
4. Screw on the ring nut and tighten it slightly.
5. Mount the machine mouth by following the instructions in the relevant paragraph.
Summary of Contents for TC 22
