Sirius XM RAdio PowerConnect+, User Manual

Page: 30 / 60

30
• Sedan/Coupe With Antenna Placed at the Rear of the Roof:
1 . Feed the antenna cable from the antenna underneath the rubber molding
around the rear window . Use a blunt plastic putty knife or similar blunt tool
to lift the rubber molding around the rear window and tuck the antenna
cable underneath the molding . Route the antenna cable around and down
the window to the lowest point . If your rear window does not have rubber
molding, we recommend consulting a professional installer .
2 . Route the antenna cable out of the window molding and into the rubber
weather stripping around the trunk opening . Lift the weather stripping
from the opening and tuck the cable inside it, then replace the weather
stripping . To avoid sharp bends in the cable, run the cable inside the
weather stripping for a few inches, then remove the cable from the
weather stripping inside the trunk . Keep the cable away from hinges,
gears, etc ., that could damage it .
3 . Route the cable out from the rubber weather stripping and along the trunk
wall . Continue routing the cable into the vehicle cabin through a conduit or
along an existing wiring harness .
4 . Route the cable through the main cabin area under the interior trim,
towards the front of the vehicle . Use a blunt plastic putty knife or similar
blunt tool to lift the plastic trim
just enough to tuck the cable
under underneath . Avoid side
airbag locations on back pillars
and above the doors . Airbag
locations are marked with “SRS”
logos . Be careful not to crimp or
cut the cable .
5 . Bring the cable out from the trim
near the front of the cabin and
route it under the carpet toward
Vehicle Installation