● Ensure that the unit case is properly earthed, connecting all the earth ground
studs. Earth cable should be about 10 mm longer than the other cables on the
connector, in such way that it will not be accidentally disconnected when the
cable is stretched or pulled.
1. Open the housing
a)
Loosen the screw at the bottom of the
external rail. The screw is fixed to a nut
welded on the housing.
b)
Unscrew the two M6 screws on the rear
flange.
c)
Slide the housing outer body away from the
back flange.
Be careful not to lose screws, washers and
O
‑
rings.
2. Secure the housing body
● Hang the housing body inserting the pin into
the slot on the bracket in order to perform
electrical connections and maintenance asks
inside the housing.
3. Install the camera
a)
Mount the camera on the internal rail using
one of the ¼” screws supplied and the plastic
washer.
b)
Use the included spacers to adjust its height
position.
c)
Feed the cables through the cable glands on
the rear flange and perform electrical and
video connections according to the
instructions in the camera installation
manual.
4. Perform electrical connections (board)
● Perform the electrical connections on the board
according to the following indications:
- 24 Vac version: supply voltage (on "LINE"
connector: line on L pin and neutral on N pin).
- 230 Vac version: supply voltage (on "LINE"
connector: line on L pin and neutral on N pin).
SA Fixed Series - Installation manual
6
