SIP SILVERCUT DISC 300 F ALP, Manual, Page: 166 / 190

SILVERCUT
37
3.4 Adjusting the grass cut width
For the purpose of forming swaths of different widths,
the mower is equipped with a continuously adjustable
guiding reel (1) on each side.
– Perform the repair work, maintenance,
cleaning and stopping works only with
the switched off drive and stand still
engine! Remove the ignition key.
–
Unscrew the nut (1).
– Adjust the guiding rail to the desired width.
– Tighten the nut (1).
3.5 Adjusting the tension of the tines-kneading
machine
The tines-kneading machine has adjustuble flap for
adjusting the intensity which increases and reduces
the space between the flap (1) and rotor tines (2).
The fodder dries faster if the kneading intensity is
higher.
– Adjusting the tension of the tines-
kneading machine as well as
elimination of stoppings and obstacles
must be performed with the switched
off drive and stand still engine! Remove
the ignition key.
Adjusting the flap of the tines-kneading machine:
–
Pull out the pin (4) and set the lever (3) into the
position (A) – flap slightly opened – higher intensity
– or to position (B) – opened flap - lower intensity.
– Loosen the pin (4) to let it stuck in the position
hole.
1
1
1 2
3
A B
4