14
DO NOT
use the abrasive cut off saw if it is, or has parts that are worn, dam-
aged or missing; remove from service and have the parts repaired / replaced
using original spare parts.
Clean the abrasive cut off saw after each use.
Check the disc and guards for wear or damage before each use.
The abrasive cut off saw should be stored in a clean and dry environment.
Note:
Disconnect the abrasive cut off saw from the mains supply before changing
accessories, servicing or performing maintenance. Replace or repair damaged
parts. Use genuine parts only. Non-authorised parts may be dangerous and will
invalidate the warranty.
MAINTENANCE
CHANGING THE DISC
Remove the 2 nuts (G) and remove the moving disc guard (H) (Photo 004).
Rotate the disc until you find the inner flange cut out (I) (Photo 005).
Place a hex. key (L) on to the disc bolt (J) (Photo 005).
Push the disc lock pin (K) inwards so it sits inside the inner flange cut out (this will
hold the abrasive disc so it wont be able to move whilst you undo the disc bolt)
(Photo 005).
Whilst the disc lock pin is still pushed inwards, turn the hex. key (L) anti-clockwise
to undo the disc bolt (Photo 005).
Remove the disc bolt, washer, outer flange and abrasive disc, place the new
disc over the shaft and follow these steps in reverse to fit and secure the new
disc.
Note:
The abrasive disc must be rated above 3800rpm and be within the
expiry date, any disc rated below this or expired could shatter and possibly
cause injury to the operator or people nearby.
004
G
H
005
I
J
K
L
11
TECHNICAL SPECIFICATION
SIP Part No.
01308
01315
Input Voltage
230V
110V
No Load Speed
3600 rpm
3400 rpm
Input Power
2400W
2000W
Disc Size
355mm
355mm
Bore Size
25.4mm
25.4mm
Round Tube @ 0˚
130mm
130mm
Round Tube @ 45˚
110mm
110mm
Square Box Section @ 0˚
120mm x 120mm 120mm x 120mm
Square Box Section @ 45˚
90mm x 90mm
90mm x 90mm
Rectangular Box Section @ 0˚
180mm x 85mm
180mm x 85mm
Rectangular Box Section @ 45˚
100mm x 80mm
100mm x 80mm
Angle Iron @ 0˚
140mm x 140mm 140mm x 140mm
Angle Iron @ 45˚
90mm x 90mm
90mm x 90mm
