12
GETTING TO KNOW YOUR ABRASIVE CUT OFF SAW
Ref. No.
Description
1.
Trigger switch
2.
Handle
3.
Spark deflector
4.
Vice
5.
Vice handle knob
6.
Moving guard
2
3
4
5
6
1
13
OPERATING INSTRUCTIONS
TO RAISE THE HEAD
To raise the head prior to cutting, push the head down
and pull out the head lock pin (Photo 001) and the
head will raise.
MAKING A CUT
The vice jaw can be set in 3 different positions depending on the size of material to be
cut, the vice can be adjusted to 45
˚
left or right; To set the vice jaw follow the steps
below.
Remove the 2 bolts (A), if required (Photo 002).
Move the vice jaw (B) over hole (C or D), de-
pending on what size material is too be cut.
Refit the 2 bolts but do not tighten yet.
Move the vice jaw to the angle to be cut be-
tween 0
˚
& 45
˚
left or right
.
Retighten both bolts.
Place the material against the vice jaw (B), lift
the clamp nut (E) (Photo 003) and push the vice
handle knob (F) up against the material, push
the clamp nut (E) down and tighten using the
Vice handle knob (F).
Plug the machine in to the mains supply and
switch on.
Depress the trigger switch on the handle to start
the machine, once the cut is made let go of
the trigger switch and the machine will stop.
Head lock pin
001
A
002
B
C
D
Danger / Caution:
The abrasive disc bolt must be tight at all times, check
before each use and at regular intervals during operation.
E
F
003
