12 | Sinterit POWDER SIEVE User Manual
6. Sieving process
ATTENTION!
•
Before starting any job with the powders, always wear Protective Glasses, Protective Dust
mask, and Protective Gloves.
•
You can use the “PERSONAL PROTECTION” set included with Sinterit Lisa printers.
CAUTION!
•
The Lid
1
is heavy!
•
The danger of crushing upper limbs when lowering the Lid or closing the Door.
1. Open the Door
6
and check that the Metal container
A
is properly and tightly fitted under the Flange
12
. If necessary,
install a new one.
2. Close the Door by pressing it gently.
3. Open the Lid, holding the Door’s housing with your other hand.
4. Gently pour the powder from the Metal container (or from Lisa/Lisa PRO printer) into the Removeable Metal Sieve
11
.
5. Clean the space around the Removeable Metal Sieve (e.g. using a brush). Pay special attention to the endstops
16
near the Lid hinges (Image 7).
16
16
Image 7. Position of the Lid’s endstops.
6. Holding the Lid handle, close it.
7. Press the Power button
4
quickly. The device should start working.
8. The powder sieve will work for about 18 minutes, then it will automatically switch off.
9. If the whole powder is already sieved, you can stop the powder sieve faster manually, by pressing for 3 sec the Power
button.
