Sinoboom GTJZ0608, Operation Manual

Page: 26 / 37

4. Fold failings at both sides, and hands shall
not be placed where might get hurt.
5. Remove the two wire rope safety pins at
the rear of the fixed platform.
6. Carefully open the door and move it onto
the ladder or floor.
7. Fold the door and right and left railings at
the entrance into one device. Hands shall
not be placed where might get hurt.
8. Fold railings at both sides. Hands shall not
be placed where might get hurt.
When using, unfold the platform railings in the
converse sequence. Use the wire rope safety
pins when unfolding railings at each side to
make sure accurate installation.
Position relationship of platform railings refers
to the Whole Vehicle Instructions.
Operate with the Controller on the
Ground
It is necessary to keep safe distance between
operator, machine and fixed object.
Pay attention to the traveling direction of the
machine when using the controller.
Electrical level light for storage battery
Use the diagnostic reading display on the
platform to determine the storage battery energy.
Display of electric quantity for platform Proportion Description
90-100%
The battery
has been
fully
charged
70%
70% of the
battery
capacity
50%
50% of the
battery
capacity
30%
30% of the
battery
capacity
20%
The batter
level is low
and the
battery
must be
re-charged
10%
The battery
level is very
low and the
machine
action
becomes
slow
Charge Storage Battery

Do not use external charger.

Charge the storage battery in a
well-ventilated place.

Charge with the correct AC input voltage
indicated on the label.
1. Make sure the storage battery is well
connected before charging.
2. Remove the storage battery ventilation
cover.
3. Check the acid liquid level of the storage
battery. If necessary, replenish the distilled
water through the filling pipe at the top of
the storage battery. Add only enough
distilled water to cover the plate and do not
overdo it during charging.
4. Install the ventilation cover.
5. Connect the storage battery charger to the
grounded AC circuit.
6. The charger will give instructions when the
storage battery is charged fully.
7. Check the storage battery acid level at the
end of charging cycle. Add distilled water
24
GTJZ0608 & GTJZ0808 & GTJZ1012 & GTJZ1212 & GTJZ0612 & GTJZ0812
Operation Manual