© Jun 2020
5-2
GTJZ0408SE&0608SE&0408ME&0608ME Operation Manual
•
Check battery for leaks and proper liquid level. Add
distilled water as needed. See
.
•
Check whether the protective device in use matches
the type of work performed and conforms to relevant
technical standards.
INSPECTING PARTS
Check the machine for any damaged, improperly in-
stalled, loose or missing parts and unauthorized
changes:
•
Electrical components, wirings and cables
•
Hydraulic power unit, fuel tank, connector, hose, hy-
draulic cylinder and valve block
•
Storage battery pack and its connection
•
Drive motor and brake
•
Wheels
•
Safety arm
•
Limit switch and horn
•
Alarms and indicator lamps
•
Nuts, bolts and other fasteners
•
Platform entry door
•
Pothole guard device
•
Platform in extended state
•
Scissor arm (pivoting) and fastener
•
Platform joystick
INSPECTING ENTIRE
MACHINE
Inspect the entire machine for damage:
•
Cracks in a weld joint or structural par
•
Dents or other damage
•
Severe rust, corrosion or oxidation
•
Missing or loose structural parts and key compo-
nents, including fasteners and pins for correct posi-
tioning and tightness
•
The folding platform’s ability to support the platform
side rail and proper installation of safety pin with
wire rope
INSPECT HYDRAULIC OIL
LEVEL
Maintaining the proper hydraulic oil level is critical to
the machine’s ability to function. An improper hydraulic
oil level will damage the hydraulic parts of the machine.
Inspecting the hydraulic oil level as part of a daily ma-
chine inspection can reveal potential problems in the
hydraulic system.
Perform the following procedures with the platform
retracted:
1.
Open the right door and inspect the side of the hy-
draulic oil tank. The hydraulic oil level should ap-
pear within the “max” and “min” mark in the oil tank.
2.
Add hydraulic oil as needed. Never overfill the tank.
Table 5-1
CUSTOMER
REQUIREMENTS
HYDRAULIC OIL
MARK
Normal-temperature region
0°C to 40°C (32°F to 104°F)
L-HM46
Cold region
-25°C to 25°C (-13°F to 77°
F)
L-HV32
High-temperature region
greater than 40°C (104°F)
L-HM68
Extremely cold region
less than -30°C (-22°F)
Special programmes
need to be identified.
NOTE:
The manufacturer can add different hydraulic
oil (based on your requirements) to the machine be-
fore leaving the factory. Never mix hydraulic oils.
INSPECTING THE BATTERY
The condition of the battery affects the performance of
the machine. Improper levels of battery electrolyte or
damaged cable and wiring may harm battery parts and
may pose dangerous conditions.
NOTICE
After the battery is fully charged, wear protective
gloves for inspection.
•
Check the acidic liquid level of the lead-acid battery.
If needed, refill the distilled water through a filling
line above the lead-acid battery. Only add enough
distilled water to cover the plate. Never overfill the
tube at the end of the charging cycle.
Summary of Contents for 1530SE
Page 2: ......
Page 6: ...This Page Intentionally Left Blank ...
