Singer SGR-600LED, Instruction Manual

Page: 8 / 36

8
ENGLISH
Cord clamp
When not in use, the iron cord and power cord shall be stored. Pull out the cord clamp fi rst, after
winding the cord around the cord winding groove, push the cord clamp back.
Locking pin
The iron can be secured onto the thermal insulating cushion by the locking pin.
Automatic power off
The appliance will be automatically turned off if no steam sprayed out from the soleplate for 10
minutes.
BEFORE FIRST USE
1. Remove any sticker, protective foil or storage cover from the soleplate.
2. Heat up the iron to maximum temperature and iron over a piece of damp cloth for several
minutes for the purpose of removing any residue on the soleplate according to the section of
“Steam ironing”.
NOTE: It is normal that strange odor comes out from the unit for the fi rst use. This will
cease after a short while.
NOTE: Some particles may come out of the soleplate when you use the iron for the
fi rst
time. This is normal; the particles are harmless and stop coming out of the iron after a
short while.
NOTE: When you switch on the appliance, the steam generator may produce a pumping
sound. This is normal; the sound tells you that water is pumped into the steam generator.
NOTE: During the heating process of the soleplate, there will be little steam coming out
from the soleplate automatically and this phenomenon will continue for about 3 seconds,
this is normal.
USING YOUR STEAM STATION
The appliance has two ironing options. You can use dry ironing or steam ironing, the details are
referred below:
Dry ironing
1. Place the steam station on a stable and horizontal surface.
2. Press the release button with one
fi nger and grasp the iron’s handle with your hand, then
rotate the iron anti-clockwise (see Fig. 1) to take out the iron, and then put the iron on the
steam generator’s front hook. You do not need to secure the iron onto the thermal insulating
cushion during the operation; you can just put the iron on the front hook for convenient using.