10
3
、
Installation
3.1 Unpacking Inspection
1. Open the packing box of UPS and take it out, visually examine the unit for transit
damage.
2. Check against the accessory lists that the accessories of the UPS are present. (Refer to
Table 3-1).
3. If the UPS arrives damaged, or there is any missing accessory, please contact the
distributor immediately.
Table 3-1 Accessory list of UPS
Model
Accessory
Quantity
Unit
Input power cord
1
Pcs
RS232communication line
1
Pcs
User manual
1
Pcs
Standard Model
1KR~3KR
A Winpower software CD
1
Pcs
Input power cord
1
Pcs
RS232 communication line
1
Pcs
User manual
1
Pcs
A Winpower software CD
1
Pcs
Long backup
Time
1
KR-XL~3KR-XL
External Battery Cable
1
Pcs
Input power cord
1
Pcs
RS232 communication line
1
Pcs
User manual
1
Pcs
A Winpower software CD
1
Pcs
standard/ long
backup Model
6KR(XL)~ 10KR(XL)
External Battery Cable
1
Pcs
3.2 Installation Notes
1. When locating the UPS, make sure there is no hazardous objects around the UPS, and that the
installation environment meets the specifications.
2. The UPS should not be titled. The air inlet port at the front panel and the outlet port on the
rear panel and two side panels should not be blocked so as to ensure good ventilation.
3. In case if the UPS is unpacked, installed and used at very low temperatures, condensations of
water drops may appear. It is necessary to wait until the UPS fully dried inside out before
proceeding to installation and use. Otherwise, they may be a risk of electric shock.
4. Place the UPS near the utility power source outlet which supplies power to the UPS. In any
emergency, switch off the main input socket, cut off the battery voltage input. All power
sockets must be connected with ground protection.
