IMPORTANT INFORMATION
Please read the operating instructions carefully before installing and using the infrared heater.
This user manual contains important information for your safety as well as recommendations on the correct use and
maintenance of the appliance.
WHAT'S IN THE BOX
Infrared heater equipped with flexible cable and Shuko plug.
Instructions for use and installation.
One box containing 2 sets of brackets.
An infrared remote control (AAA batteries not included)
SAFETY INSTRUCTIONS
Certain precautions must be observed when using the infrared heater. Improper use without observing the
precautions can cause damage to the health of the user and other persons as well as damage to their property.
Use only the voltage indicated on the heater's nameplate.
Connect the appliance only to a correctly installed power outlet with earth contact.
The heater must be connected to the power supply via a2-pole circuit breaker.
It is strongly recommended to use a 30mA differential switch.
The unit must be handled with care and avoid vibration or shock.
Do not use the unit in areas where petrol, paint or other flammable liquids are used or stored.
Do not use the appliance particularly in dusty environments or where explosives are stored.
Do not use the appliance on a construction site, in a greenhouse, in a barn or in animal stables.
Do not use the appliance as a sauna heater.
Heating: Do not touch the radiant plate. The temperature of the radiant plates during operation of the heater can
reach 380 °C. To avoid burns, do not touch the surface of the appliance with your hands and other body parts. It is
also necessary to avoid touching the heater while the appliance is switched on, as serious burns may occur. The
appliance may take up to 1 hour to cool down after switching off.
Do not place any clothes, towels or similar on top of the heater to dry. Risk of overheating and fire
Do not leave the heater unattended during use.
Do not use this heater on a wet surface, or where it may fall or be pushed into water.
Do not touch an appliance that has fallen into the water. Switch off the power first and unplug it immediately.
If the power cable is damaged, it must be replaced by an authorized electrician.
If the heater is defective, it must be checked and repaired by the manufacturer, its service agent or similarly qualified
persons.
Do not use the appliance with wet hands.
Use this device only as described in this manual. Any other use is not recommended by the manufacturer and may
cause fire, electric shock or injury.
Do not use abrasive products for cleaning this appliance. If the body gets dirty, clean the dust with a cloth, the
radiant boards must be cleaned cold with a soft damp cloth. Always remove the plug from the mains before cleaning.
The heater must be installed by an authorized installer at least 2.2 m from the floor
The heater must not be placed immediately under a power outlet. The socket must not be located on the back of the
heater. The power outlet must be located outside the physical footprint of the unit to minimize heat build-up behind
the heater.
The system must be equipped with a standard power supply point with a break contact distance of at least 3 mm.
The standard power outlet must be installed by an authorized electrician.
If the heater is to be mounted in slope (e.g. inclined or angled ceiling), make sure that the electrical connection is
positioned at the lowest point of the heater.
Do not connect the appliance to the power source until it has been installed in its final position and adjusted to the
position where it will be used.