Setup for Spool Gun welding with gas shielded MIG wire
6.3.4. Operation of the Stick welding method
1. Selection of the welding method:
1) In the main interface, press the MENU key to
enter the function selection interface;
2) In the function selection interface, rotate L
Knob to select the Stick welding method and
press it for confirmation. Refer to Fig. 1;
2. Selection and setting of welding parameters:
1) In the main interface, press the MENU key to
enter the welding parameter setting interface;
2) In the welding parameter setting interface,
rotate L Knob to select the parameter as re-
quired and rotate R Knob to set a value for the
parameter, afterwards, press L Knob or R Knob
for confirmation as shown below:
Welding parameters
available by rotating
L Knob
Welding parameters
available by rotating
R Knob
Hot Start
0-10
Arc Force
0-10
2. Selection and setting of welding parameters:
1) In the main interface, press the MENU key to
enter the welding parameter setting interface;
2) In the welding parameter setting interface,
rotate L Knob to select the parameter as re-
quired and rotate R Knob to set a value for the
parameter, afterwards, press L Knob or R Knob
for confirmation. Refer to Fig. 2;
3. Setting of wire feed rate and welding current:
1) Press the ENTER key to enter the welding in-
terface shown below:
2) In the welding interface, rotate L Knob to set
the wire feed rate (1.5 – 13.0 m/min) and rotate
R Knob to set the welding voltage (10 - 27 V);
3) After the settings, press L Knob and R Knob for
confirmation;
4) Spool Gun turn on (up):
1.995.234 EN - Rev. 1.1
NOVAMIG 320 LCD
23