3. Setting of welding current:
1) Press the ENTER key to enter the welding in-
terface as shown below:
2) In the welding interface, rotate L Knob to set
the welding current (10 - 200 A), and then
press it for confirmation;
3. Setting of welding voltage:
1) Press the ENTER key to enter the welding in-
terface shown below:
2) In the welding interface, rotate L Knob to set
the welding current (10 - 200 A), and then
press it for confirmation;
6.3.5. Operation of the TIG Lift welding method
1. Selection of the welding method:
1) In the main interface, press the MENU key to
enter the function selection interface;
2) In the function selection interface, rotate L
Knob to select the TIG Lift welding method
and press it for confirmation. Refer to Fig. 1;
2. Selection and setting of welding method:
1) In the main interface, press the MENU key to
enter the welding parameter setting interface;
2) In the welding parameter setting interface,
rotate L Knob to select the parameter as re-
quired and rotate R Knob to set a value for the
parameter, afterwards, press L Knob or R Knob
for confirmation as shown below:
Welding parameters
available by rotating
L Knob
Welding parameters
available by rotating
R Knob
Two/four Stroke
2T/4T
Pre-flow
0-2 S
Down Slope
0-10 S
Post Flow
0-10 S
1.995.234 EN - Rev. 1.1
NOVAMIG 320 LCD
24
