Sinclair SF-51H, User Manual

Page: 27 / 32

Fan Coil Unit Wall Mounted Type
23
9. Install the unit
9.1 Install the rear panel
(1) Always mount the
rear panel horizontally. Due
to the water tray of the unit
has been adopted the both-
way drainage design, the
outlet of water tray should
be adjusted slightly down
when installing, that is taking
the outlet of the water tray
as the center of a circle, the
included angle between the
evaporator and level should
be 0 or more, that is good for condensing water drainage.
(2) Fix the rear panel on the wall with screws. (Where is pre-covered with plastic granula)
(3) Be sure that the rear panel has been fixed firmly enough to withstand the weight of an adult
of 60kg, further more, the weight should be evenly shared by each screw.
9.2 Install the piping hole
(1) Make the piping hole (Ф55) in the wall at a slight
downward slant to the outdoor side.
(2) Insert the piping-hole sleeve into the hole to
prevent the connection piping from being damaged when
passing through the hole.
9.3 Install the water drain pipe
(1) For well draining, the drain hose should be placed
at a downward slant.
(2) Do not wrench or bend the drain hose or flood its
end by water.
(3) When the long drainage hose passing
through indoor,
should wrap the insulation materials.
NOTE:
When connecting the electric wire if the wire
length is not enough, please contact with the
authorized service shop to buy a exclusive electric
wire that is long enough and the joint on the wire
are not allowed.
● The electric wiring must be correctly connected, wrong connection may cause spare parts
malfunction.
● Tighten the terminal screw in order to prevent loose.
● After tighten the screw, slight pull the wire and confirm whether is it firm or not.
● If the earth wire is wrong connection, that may cause electric shock.
● The cover plate must be fixed, and tighten the connection wire, if it is poor installed, that the
dust, moisture may enter in or the connection terminal will be affected by outside force, and will
cause fire or electric shock.
55
Indoor
Outdoor
Wall pipe
Seal pad
Wrenched
Bent
Flooded
150mm 150mm
Wall Wall
Mark on the middle of it
Gradienter
Left
Right
(Rear piping hole)
(Rear piping hole)
Space
to the
wall
above
Space
to the
wall
above
Fiig.15