Page 52
The safety sensors, motion stop switch and seat belt sensor should always
be enabled (in the “ON” setting) during all normal situations. The feature to
disable the safety settings should be used only in special situations, for
example when an attendant is present near the machine, solely under the
discretion and responsibility of the operator.
Simuline Inc. will not be liable
for any accidents or damages resulting from operation of Cycraft with any of
the safety features disabled.
6.5.2 SETTING TCP/IP CONFIGURATION
This function allows the TCP/IP setting of the motion board to be set. The motion
computer and the game computer are connected via TCP/IP. All settings are preset
in the factory but for future upgrades and maintenance, it may be necessary to adjust
settings.
1) Bring up the configuration main menu by pressing the MENU/SET button for 2
seconds.
2) Highlight the “3. SETUP TCP/IP” item by using the UP and DOWN buttons. The
highlighted item is indicated by the “=>” sign.
3) Press MENU/SET button to bring up the TCP/IP setting sub-menu.
4) Highlight and select the desired parameter and use the UP and DOWN buttons to
change the values.
The following are the factory pre-set values for the Club Kart game.
IP ADDRESS : 192.168.1.1
SUBNET MASK : 255.255.255.0
GATEWAY ADDR: 192.168.1.1
[SET TCP/IP]
=> 1. IP ADDRESS
2. SUBNET MASK
3. GATEWAY ADDR
4. EXIT
Summary of Contents for Cycraft
Page 16: ...Page 16 3 NAMES OF MAJOR PARTS 18 11 12 13 14 15 16 17 28 ...
Page 30: ...Page 30 Hexa bolt M8 x 30L DU Bush 10 15 Rubber Washer 11 20 3t Spring Washer Flat Washer ...
Page 73: ...Page 73 10 2 Cabin Schematic SCHEMATIC 2 HERE ...
Page 74: ...Page 74 10 3 MCU Schematic DOCUMENT END SCHEMATIC 3 HERE ...