SIMULINE INC..
66
③
Check Error Code next to Status of Motor Driver (1) and (2) on the Motion Control BD Information
Screen.
< [FF00] Error Screen >
Refer to the following error message table.
■ Motor Control BD Error Message Table
Error Code
Cause
Countermeasure
FFOO
It occurs when Encoder Connector
on Motor Drive BD is pulled (J11)
[Check Encoder Connector]
Check if Motor Drive BD Encoder Connector on MCU is
connected or if Connector cable is not damaged.(J11)
FFFF
FFC7
It occurs when Motor Drive BD
does not receive Encoder
information
[Check 5V SMPS output power]
1. Check if the voltage between DGND and +5V is
DC5.0V~5.2V.
2. If it is normal (1) but if the same problem is repeated,
contact the manufacturer or the seller.
F800
Motor Drive BD +12V Relay
K
5
•K
8
contact problem
If SMPS (RD-65A) +12V output voltage is normal,
m12V power in Motor Drive BD J7 Connector.
If there is no +12V power, check connection Harness.
FFFE
It occurs when Actuator Limit
Sensor cannot be found
1. Check Actuator Limit Sensor Joint and Connector.
2.If it is normal (1) but if FFFE Error is repeated in
specific Motor Drive BD, contact the manufacturer or the
seller to replace the Motor Drive BD.
90AE
9086
It occurs the moment it moves as
Actuator 1 & 2 is turned on
(It occurs when Motor
의
Z(Zero)
Pulse cannot be found without
motor phase information)
1. If it is turned on when it is slanted, the error might
occur.
Correct the problem before resetting the system.
2.If there is a problem in Actuator Limit Sensor(Bottom
Sensor) Joint, the error might occur.
