SIMUDRIVE SD100Hz
EN
37
7
PROGRAMMING THE REMOTE CONTROLS
7.1
Memorising 2 or 4-button remote controls
NOTICE
If this procedure is carried out using a button which has already been memorised, the button will be
cleared.
1]
Press the “
PROG
” button for 2 s.
ð
The “PROG” indicator light is permanently lit.
NOTICE
Pressing “
PROG
” again allows the next function to be memorised (230 V aux output control)
2]
Press the button selected to control the function (complete opening, Aux 230 V output control).
ð
The “PROG” indicator light flashes for 5 s.
Complete opening control
Aux 230 V output control
> Illustration 21
7.2
Memorising 3-button remote controls
> Illustration 22
NOTICE
If this procedure is carried out using a remote control which has already been memorised, the remote
control will be cleared.
1]
Press the “
PROG
” button for 2 s.
ð
The “PROG” indicator light is permanently lit.
NOTICE
Pressing “
PROG
” again allows the next function to be memorised (230 V aux output control)
2]
Press "
PROG
" at the back of the remote control.
ð
The “PROG” indicator light flashes for 5 s.
Function of the 3-button remote control buttons
Function
Up button
My button
Down button
Complete opening
Complete opening
Stop
Complete closing
Aux. 230 V
Aux. output ON
Aux. output OFF
8
PROGRAMMING ON AN IO LIGHT RECEIVER
This function enables automatic activation of remote lighting connected to the receiver during garage door
movements.
1]
Switch the light receiver to programming mode (refer to the receiver manual).
2]
Briefly press the "PROG" button.
ð
The PROG indicator light flashes once.
ð
The lighting connected to the light receiver comes on and then goes out.