8/8
1
2
3
4
5
6
7
8
9
JP6
JP2
JP1
JP7
JP4
R31
R32
R33
DL2
DL1
DL14
DL3 DL4 DL5 DL6 DL7 DL8
1
ON
2 3 4 5 6 7 8 9 10
DL9 DL10 DL11 DL12 DL13
TWPED
TCA
TW
10 11 12 13 14 15
25
24
23
22
21
20
16 17 18 19
26 27 28 29 30 31 32 33 34 35 36
4.2 - Trimmer-set functions
4.3 - LEDs functions
TW.PED : no used
TW : Sets the operation time during both the opening and closing
phases (adjustable from 3 to 210 seconds).
TCA : Sets the dwell time, after which the gate closes automatically
(from 1 to 120 seconds).
The SIMUDRIVE 410 control unit is provided with leds which are useful in identifying any anomalies in the system.
■
DL1 :
Stays on when supplied with mains power and with F1 fuse intact.
■
DL2 :
Comes on when the motor is activated during closing.
■
DL3 :
Comes on when the motor is activated during opening.
■
DL4 :
Comes on following the Start command.
■
DL5 :
Goes off when the block command is activated. (stop by push button or motor thermal probe).
■
DL6 :
Goes off when photocells are not aligned, i.e. when obstacles are present. When Dip-switch 9 is OFF, the photocells and related
leds are only activated during manoeuvring.
■
DL7 :
Goes off when the shutter is in the fully open position, if provided with end-of-stroke device.
■
DL8 :
Goes off when the shutter is in the fully closed position, if provided with end-of-stroke device.
■
DL9 :
Not used.
■
DL10 :
Comes on with manual opening command.
■
DL11 :
Comes on with manual closing command.
■
DL12 :
Goes off when the safety edge is activated. When Dip-switch 10 is OFF, the edge and its related LED are only activated during
manoeuvring.
■
DL13 :
Comes on when the safety ring is closed. (self test).
■
DL14 :
Not used.
