Simtronics MultiTox DG-TT7-S, Operating Manual

Page: 35 / 59

MultiTox : DGi-TT7-E/O & DG-TT7-S
Page 35 / 60 NOSP 16452-05 (08/2016)
6.7. Information menu [INFO]
The information menu contains all information concerning the identity and settings of the
detector. The first screen gives the detector’s reference and its serial number.
6.7.1. [IDEN]tity submenu
Presentation of:
•
The serial number
•
The device reference
•
The scale and the targeted gas
Sub-menus present the board software version, the power supply voltage and the
temperature read in the cartridge.
6.7.2. [OUT]put submenu
Presentation of:
•
Current protocol (0-20 mA or 4-20 mA).
•
Normal state of the relays (normally open or normally closed).
•
Condition of relay activation.
Relays can be set with a level 2 access.
6.7.3. [STAT]e Information submenu
Presentation of:
•
Number and value of activated alarm levels.
•
List of eventual faults (press F1 key to scroll through the list)
•
Possibility to acknowledge alarms
6.7.3.1. [ALRM] Alarm screen
Allows setting of levels and alarms acknowledgement.
6.7.3.2. [FLT.] Fault screen
Displays a list of eventual faults (press F1 key to scroll through the list) and allows their
acknowledgment.
6.7.3.3. Network screen: switch state
This menu and its sub-menus are used for the network detector settings. For any further
details, please refer to the Syntel system operating manuals.
MODE SCREEN
The first line shows the operating mode of the sensor in the network (logic link test / out of
order / emulation).
The second line shows if the network part of the detector is “operating” or “out of order”. For
any further details, please refer to the Syntel system operating manuals.
NETWORK SCREEN: ALIM
Information displayed:
•
Voltage A: ON / OFF
•
Voltage B: ON / OFF
For any further details, please refer to the Syntel system operating manuals