SIMREX DataMover ESS, User Manual

Page: 81 / 188

SIMREX MAN.ESS-01, Rev. F DataMover ESS User’s Guide 73
SIMREX Corporation
Invisible place holder
Figure 3-31. IP-to-Serial Application Diagram
3.6.7 Point-to-Point Serial-to-Serial Application
Example
Once the transceivers are configured and the changes have been exe-
cuted, they begin processing any data presented at the
COM
ports. Data
presented at the Access Point’s
COM
port will be packetized and sent via
UDP to the Remote. Upon receiving the packet, the Remote strips the
data out of the UDP packet and sends it out its
COM
port. Likewise, data
presented at the Remote’s
COM
port is packetized, sent to the Access
Point, stripped, and sent out the Access Point’s
COM
port. Note, this
configuration does not use multicast addressing.
Invisible place holder
Figure 3-32. Point-to-Point Serial-to-Serial Application Diagram
Table 3-1. Serial Port Application Configuration
IP-to-Serial Connection
Transceiver
Location Menu Item Setting
Access Point None is required None is required
Remote Unit IP Address 192.168.0.2
Status Enabled
IP Protocol TCP
Baud Rate 9,600 (Example)
Flow Control None
Local IP Port 30011
Table 3-2. Serial Port Application Configuration
Transceiver Location Menu Item Setting
Access Point (COM2)
1
Status Enabled
Data Baud Rate 9,600 (Example)
Flow Control Hardware (Example)
Serial Mode Seamless